Raytheon RayChart 620, Operation Manual

Page: 41 / 121

28 RayChart 620
Leg The leg number
Position The position of the waypoint for this leg, as selected
by the cursor position when you made the route.
The position is given as either latitude and longitude
or TDs, depending on your setup selection.
WPT Name The waypoint name. The default name is in the
format
xxx WPT, where xxx is the waypoint number.
You can give the waypoint a name of up to 16
characters, which can be letters and/or numbers.
Depending on your setup selection, the full name or
only the first 3 or the first 6 characters may be
displayed on the chart.
Waypoints are listed in the Waypoint List in
alphanumeric order of name (see Chapter 4). If you
plan to use the Waypoint List, you may wish to
name related waypoints so that they are grouped
together in the list.
Sym The waypoint symbol. The default is a circle, but you
can change it to any of the mark/event symbols (see
page 35).
Source The source of the position information. For on-
screen routes, this is always the cursor. If you edit
the position, the source is updated to “EDIT”.
You can change the route name or the waypoint positions, names
or symbols.
2. Use the left or right sides of trackpad to move the cursor to the
number, letter or symbol you wish to change. You can hold the
trackpad down to move quickly, or press ENTER to skip to the start
of the next field.
3. Use the top or bottom of the trackpad to increase or decrease the
number, or change the letter or symbol.
4. Repeat steps 2 and 3 until the required information is displayed.
5. When you have finished editing the data, you can either:
• Press the SAVE & EXIT soft key to save the changes and return
to the default screen
or