Chapter 6: Installation
77
6. Attach the socket to the bulkhead using the two self-tapping
screws. Secure the drive cable at regular intervals, using cable
clamps.
6.7 NMEA interface
ST4000 Plus will accept navigation data in the NMEA format for use in
Track and Vane (WindTrim) modes. The required data formats are
shown in the table at the end of this section.
Cabling
The NMEA data port is on the rear of the ST4000 Plus and should be
connected to a Navigator or Wind Instrument.
Summary of Contents for ST4000 Plus
