Raymarine ST4000 Plus, Owner'S Handbook Manual

Page: 53 / 119

40 ST4000 Plus Wheel & Tiller Autopilots Owner’s Handbook
ï For each setup page, scroll forwards or backwards through the
available data pages, using the
+1
or
-1
keys, until the required page
title is displayed.
Note: If you set a page to NOT USED, it is omitted from the display
cycle during normal operation. For example, with the default page
settings only three pages are displayed in the sequence.
There are 3 depth pages and 2 water temperature pages. Data is
displayed in the units defined by the selected page.
ï Press
disp
to move on to the next Data Page selection screen, and
repeat the selection procedure.
Note:
If a man overboard (MOB) message is received by the autopilot,
the BTW and DTW pages will display the bearing and distance to the
MOB location, so it is good practice to retain these pages for display.
5.2 Dealer Setup
Dealer Setup allows you to customise the autopilot to your boat.
However, the factory default settings will provide safe performance for
the initial sea trial, and fine tuning is not normally required. The flow
chart on the next page shows you how to enter Dealer Setup, scroll
through the setup displays, adjust the values and exit. The features that
can be adjusted are listed in the table following the flowchart. If you
change any of the settings you can record them in the
New Setting
column for future reference.
Information on the functions of the different settings is given in the
remainder of this section. The following points should be noted:
ï Make sure that the autopilot is in Standby mode before you access
Dealer Setup
ï Setup options are always saved on exit