Boat details
To ensure correct operation and display of data you should set the Boat
Details settings according to your requirements.
Boat details can be accessed from the
[Settings]
menu:
[Homescreen >
Settings > Boat Details]
Option
Description
[Min safe
height:]
Enter your vessel’s maximum unladen height from
the waterline. To ensure adequate clearance, it is
recommended that you add a safety margin to this figure
to allow for variation caused by vessel movements.
[Min safe width:]
Enter your vessel’s maximum width at its widest point.
To ensure adequate clearance on both sides, it is
recommended that you add a safety margin for port and
starboard to this figure to allow for variation caused by
vessel movements.
[Min safe
depth:]
Enter your vessel’s maximum depth when fully laden.
This is the depth from the waterline to the lowest point
on the vessel’s keel. To ensure adequate clearance, it is
recommended that you add a safety margin to this figure
to allow for variation caused by vessel movements.
[Num of
engines:]
You can configure your system to display data for up
to 2 engines, when connected to a compatible engine
management system.
[Identify
engines:]
Once you have selected the number of engines, select
[Identify engines]
and follow the onscreen instructions to
configure your engines. May require an extra hardware
interface to enable engine data to be displayed.
[Fuel tanks:]
You can configure your system to display data for up
to 2 fuel tanks.
[Fresh water
tanks:]
You can configure your system to display data for up to
2 fresh water tanks.
[Live well tanks:]
You can configure your system to display data for up
to 2 Live well tanks.
[Gray water
tanks:]
You can configure your system to display data for a Gray
water tank.
Option
Description
[Black water
tanks:]
You can configure your system to display data for a
Black water tank.
[Batteries:]
You can configure your system to display data for up to
3 batteries.
[Transducer:]
You can select the transducer type that is connected
to your display.
Important:
Ensure the display is powered off before physically
changing your transducer.
Units of measure
You can select your preferred units for data readings from the
[Units]
menu:
[Homescreen > Settings > Units]
.
Default units of measure are determined by the selected user interface
language.
Measurement
Units
[Distance units]
•
[NM & ft]
— Nautical miles & Feet
•
[NM & m]
— Nautical miles &
Meters
•
[mi & ft]
— Miles & Feet
•
[km & m]
— Kilometers and Meters
•
[NM & yd]
— Nautical miles &
Yards
[Speed units]
•
[Kts]
— Knots
•
[MPH]
— Mile per hour
•
[KPH]
— Kilometers per hour
[Depth units]
•
[Meters]
— m
•
[Feet]
— ft
•
[Fathoms]
— Fm
116
