C120R Operator Service Maintenance Manual
26
Operation
Seat Adjustment
• 1. Adjustable Headrest - Firmly grip the headrest,
then pullor push down for your desired height or pull
it towards you.
• 2. Right Hand Side Control For Recline - To adjust the
backrest, push backwards on the black handle (located
on the right side of the seat cushion) while pushing or
pulling on the backrest of the seat.
• 3.Non-Retractable Seatbelt - 3” wide non-retractable
seat belt.
• 4. Tiltable Pod Consoles - 125mm (5”) Joystick Control
Arm. Height Adjustment -51mm (2”) Joystick Control
Arm Fore + Aft Adjustment
• 5. Weight Adjustment Knob (Air) - Push knob in to
increase air pressure/weight rating. Pull out to decrease
air pressure/weight.
• 6. Fore + Aft Adjustment - Simply pull up on the handle
bar and slide the seat either forwards or backwards then
release the handle.
• 7. Adjustable Mechanical Lumbar - To Increase lumbar
support simply rotate the knob, located on the left-hand
side of the seat. Rotate forward to increase lumbar
support, or backward to decrease.
Protective Seat Cover - (Not Shown)
A protective seat cover can be purchased separately to
increase the life of your seat. For more information, consult
your local Rayco Dealer.
Seat Belt
This machine was shipped from Rayco with a factory installed
seat belt. Consult your Rayco dealer for all replacement parts.
• Always check the condition of the seat belt and its
mounting hardware before operating the machine.
• Regardless of the appearance, the seat belt should be
replaced every three years.
• Inspect the seat belt for worn or frayed webbing.
• Check the buckle for wear or damage. If the seat belt
is worn or if the buckle is damaged, replace the seat
belt and/or the buckle.
• Inspect the belt mounting hardware. Replace any
hardware that is damaged or worn. Make sure that
mounting bolts are tight.
Seat Belt Adjustment
The seat belt is equipped with an automatic locking retractor.
The automatic retractor will lock the belt in place. Once the belt
is locked, it cannot be pulled further out. The belt must return
to its fully retracted position to allow it to be pulled out again.
Fastening the Seat Belt
• Pull the seat belt out of the retractor in a continuous
motion.
• Insert the belt tab into the belt buckle. Make sure that
the seat belt is placed across the lap of the operator.
• The automatic locking retractor will adjust the length of
the seat belt to the operator.
Releasing the Seat Belt
Depress the button on the buckle to release the seat belt.
RISK OF ACCIDENT! DO NOT OPERATE THE SEAT
ADJUSTMENTS WHILE OPERATING.ALWAYS MAKE
SURE THE MACHINE IS STOPPED WITH THE
PARKING BRAKE ENGAGED. ENSURE THAT ALL
SEAT POSITIONS AND ADJUSTMENTS LATCH
INTO PLACE WITH AN “AUDIBLE CLICK.” DOING
SO WILL PREVENT INJURY AND UNWANTED SEAT
MOVEMENT WHILE THE MACHINE IS OPERATING.
7
4
6
2
1
5
3
4
Summary of Contents for C120R
