3 ) Starting the System
To power-up the system, hold down the center button located on the Heads Up
Display (HUD). Release the button when the LCD changes. The system will
perform a quick diagnostic.
The display will show two independent temperature
readings, and system status indicators. Along the bottom are controls for the back-
light, fan (left and right button respectively), and menu access / power button.
Note:
Your system is powered by direct connection to the vehicle battery and will
remain on and functioning even when the vehicle is turned off. Therefore when
your vehicle is not in service and/or you no longer require this system to function,
you must manually turn the system OFF (press and hold the center button of the
HUD).
4 ) System Menu
Access the particular system you wish to program by first pressing the center
button on the HUD once. This brings you to the first level of the Setup menu.
To access the feature sub-menus, select the desired feature with the left and right
buttons and then press the center button to enter that sub-menu.
To change a feature option, select the desired option with the left and right buttons
and then press the center button to edit that option. The left and right buttons can
then be used to change the option value. Once the option has been set to the
desired value, pressing the center button will allow another option to be selected
for editing.
Holding the center button will exit out of the current sub-menu or menu.
F3-G2 System Manual - Rev 7
Page 8 of 33
