2.3 ) Remote / Pager
The Remote/Pager (RP) is the portable interface to the system. It displays almost exactly
the same information as the HUD. The RP will notify of an alert condition by vibrating and
beeping (unless muted in which case it will only vibrate) and can be used to reset the alert.
After approximately one minute of no buttons being pressed, the display will turn off to
conserve battery power, but the RP will continue to receive updates. The RP is equipped
with a back-light for the display which can be turned on by pressing the right button. The
RP is powered by a lithium-polymer rechargeable battery. It can be recharged using either
the included 120V wall charger or the included charging pigtail which allows the RP to be
recharged from the HUD. It could take more than an hour to fully recharge the battery but
can be left on the charger indefinitely without causing damage. This type of battery also
does not have a “memory” effect and so there is no need to fully discharge the battery
before recharging.
Note:
The Remote / Pager holster is constructed of a special polymer that can be cut to
accommodate larger fingers to access the DEPLOY K-9 Button through the holster.
F3-G2 System Manual - Rev 7
Page 7 of 33
Drawing 2.3.3: Remote/Pager Display
Drawing 2.3.1: Remote/Pager Front
Drawing 2.3.2: Remote/Pager Back
LCD Display
Multifunction
Buttons
Deployment
Button
Heat Alert
System Status
Deployment
System Status
Sensor Temperatures
Signal Strength
Battery Level
Temperature Trend Arrows
Button Label (Mute)
Button Label (Press – Back-light / Hold - Power)