8.4 ) Charge the Remote/Pager
After unpacking the System we recommend that you immediately charge the
Remote/Pager. To do this:
1. Locate the Remote/Pager and charger.
2. Plug the charger into a 120v 60hz receptacle (standard wall plug).
3. Plug the charger into the charging port on the side of the Remote/Pager.
4. The message CHARGING BATTERY will appear on the LCD screen of the
Remote/Pager.
Note:
If the Remote/Pager battery is completely dead it may take a few minutes
before the charging sequence begins.
Note:
We have provided you with a long-life Remote/Pager battery. Depending on
temperature, it can take over an hour to fully charge this device. For your
convenience, the Remote/Pager is protected by over-charge circuitry therefore it
can remain on the charger indefinitely without fear of battery damage.
8.5 ) Placement of the Control POD
Before starting your installation, consider the most appropriate placement of the
system’s Control POD in the interior of the vehicle (the POD design requires that it
be located inside of the passenger compartment). Be certain that:
1. Both wire harnesses can easily reach the Control POD as well as their
intended point of connection to the vehicle components.
2. The antenna connector can be mounted to the roof of the vehicle and still
make connection to the Control POD.
3. The Control POD/HUD Communications Cable can be routed from the Heads-
Up Display to the Control POD.
4. The Control POD can be securely attached anywhere in the interior of the
vehicle (it does NOT need to be grounded). Use the self-tapping screws
included to secure the POD to the front panel of your K-9 insert or attach
using 2-sided tape, Velcro® or any other attachment method you choose.
Note:
Take care to route all wires away from excessive heat sources and points of
possible abrasion.
F3-G2 System Manual - Rev 7
Page 17 of 33
