8 ) Installation
8.1 ) Read This First!
Installation of this system should be carried out by qualified persons familiar with
the general installation of law enforcement electronics commonly installed in police
service vehicles. It is recommended that the installer(s) have updated wiring
diagrams and schematics of the specific vehicle in which the system will be
installed or have access to wiring information through a local dealership or other
source.
If you are replacing an existing deployment and/or heat alert system, remove all
previous wiring before beginning installation. Our System requires that wiring
connections be made as described in this manual - do not connect this to any other
system’s pre-existing wires.
Any deviation from these instructions that causes damage to any part of the
system will void the warranty.
8.2 ) Before installation
1. Confirm all parts and components are included and accounted for by doing a
complete inventory of the package contents.
2. Read this manual to familiarize yourself with the system’s unique
requirements for installation.
3. Observe all safety practices. It is the installer’s responsibility to determine,
implement, and observe those safety practices.
Please note:
This system is designed to be directly hardwired to the vehicle’s 12-volt battery. Do not
connect the system to the vehicle battery until all connections have been completed and
verified as being correct.
Do not connect this product to any device intended to detect vehicle battery drain.
Doing so may “power down” this product and/or render it ineffective for its intended
use.
We recommend that you meet with the intended user to discuss preferences and
installation requirements specific to the system’s application and user comfort.
F3-G2 System Manual - Rev 7
Page 14 of 33
