dĞƌŵŝŶĂƚŽƌ^ĂůǀĂƚŝŽŶΡϰϮ͟ĞůƵdžĞ'ĂŵĞ
Page 7
dĞƌŵŝŶĂƚŽƌ^ĂůǀĂƚŝŽŶΡ'ĂŵĞ^ŽĨƚǁĂƌĞŽƉLJƌŝŐŚƚΞϮϬϭϬWůĂLJDĞĐŚĂŶŝdžΡ/ŶĐ͘ůůƌŝŐŚƚƐƌĞƐĞƌǀĞĚ͘
Check Electrical Settings
1.
Verify the voltage in the nearest AC outlet.
2.
Verify the AC outlet ground connection is present and working.
3.
Open the back door of the monitor assembly.
4.
Near the AC power transformer, verify that the voltage selector switch is set for the correct AC
voltage.
5.
Route the line cord so that the plug is near the AC outlet.
6.
Replace the back door of the monitor assembly.
7.
Move the monitor assembly a few inches from the wall.
Assemble Terminator Head
1.
Using a ladder and an assistant to hold the Terminator head assembly in place, lift the
component above rear of monitor assembly.
2.
Attach the four-pin connector of the Terminator head assembly into its mate on the rear of the
monitor assembly.
Note: Do not force connector. If it does not connect easily, turn it 180 degrees and try again.
3.
Align bracket of Terminator head assembly with the four holes in the top and on the angled back
of monitor assembly.
4.
Affix a
M
¼-
ϮϬdžϭ͟ďůĂĐŬ
TORX screw and a
O
¼-20 black flat washer by hand through each of
the two top holes.
Do not tighten screws.
5.
Affix a
M
TORX screw and a
O
flat washer by hand through each of the two holes on the angled
part of the bracket into the monitor assembly.
6.
Tighten all screws with supplied TORX wrench.
Terminator Head Installation
