Service Manual
CoinUp® Operation Overview
dĞƌŵŝŶĂƚŽƌ^ĂůǀĂƚŝŽŶΡŽƉLJƌŝŐŚƚΞϮϬ
10 T Asset Acquisition Company, LLC
Page 62
If game remains in this status more than five minutes, either the network information entered was
incorrect, or the game cannot communicate with the access point.
1.
Reboot game and return to Wi-Fi Details again.
2.
If another five minutes pass with the same status, return to Wi-Fi Setup and re-enter network
information.
3.
Check network signal strength by scanning for available networks in Wi-Fi Setup.
4.
If signal is weak, unplug AC power and move cabinet closer to the access point.
Obtaining IP Address
dĞƌŵŝŶĂƚŽƌ^ĂůǀĂƚŝŽŶΡ
has found wireless access point or router and is acquiring an IP Address.
1.
If this status displays for more than 5 minutes, reboot game.
2.
Recheck status after reboot.
Game Registration
After the reboot following CoinUp® installation, you will be prompted to register your location. You can
also register by entering the Diagnostic menu, selecting Online Menu, then Game Registration Menu
and Game Register.
1.
Press the START button to login manually. Enter ID and pin when prompted.
2.
The Select A Location screen appears
3.
The game downloads your locations from the CoinUp® server database automatically.
4.
Scroll through the list to highlight the appropriate location.
5.
Select Use This Location to continue.
6.
If the location is not on the list, select Add New Location to continue.
7.
When adding a new location, select each letter and then click OK to confirm.
8.
After location is chosen, a confirmation screen is displayed.
9.
The game checks for updates and messages, then enters Attract mode.
10.
Cell Modem and Wi-Fi users: Check signal strength indicator.
In Attract Mode, look for a five-segment bar graph. You should see the graph in the bottom-left
corner of your screen. (The indicator appears on all Attract Mode screens.)
Ethernet games also display the graph. Broadband signal strength is constant. When connected,
it displays five green bars. When disconnected, the graph shows no bars.
Checking the Connection
Cell Users
1.
Enter Diagnostic mode by pressing the TEST service button.
2.
Select Online Menu
Ͷ
Connection Details
Ͷ
Cell Modem Details.
3.
Note the signal strength, which appears as a fraction with a 5 in the denominator.
A strong signal is 5/5; a weak signal is 1/5 or 2/5.
