Service Manual
Setup
dĞƌŵŝŶĂƚŽƌ^ĂůǀĂƚŝŽŶΡŽƉLJƌŝŐŚƚΞϮϬ
10 T Asset Acquisition Company, LLC
Page 8
Attach Front Pedestal to Monitor Assembly
1.
Move front pedestal assembly a few inches away from the monitor assembly.
C
ONNECTORS
Ensure all connectors mate properly. If connectors do not slip in easily, do not force them.
Connectors are often keyed and only connect one way. Check for correct orientation.
2.
Gently pull all connectors through the round holes in the front pedestal and monitor assembly.
3.
Connect single-pin ground cable from monitor assembly to front pedestal.
4.
Connect either USB cable from monitor assembly to either USB cable from front pedestal.
Note: the USB gun cables are interchangeable. The PC will decide which is the right and left gun.
5.
Connect the 10-pin and 16-pin data/power connectors from the monitor assembly to their
mates from the front assembly
6.
Move front pedestal so that it is flush with monitor assembly.
Caution
: make sure cables are not pinched. Tuck them back through the round hole into either
cabinet.
7.
Align holes in monitor assembly brackets with holes in rear of front pedestal assembly.
Adjust leg levelers on front pedestal assembly as needed.
Monitor Assembly to Front Pedestal Installation
8.
Insert a
M
TORX screw and a
O
flat washer by hand through each of the three holes at the front
of the left bracket into the three holes of the front pedestal.
Do not tighten screws.
9.
Repeat with other bracket.
10.
Tighten all screws with supplied TORX wrench.
