Raven Sidekick Pro, Installation And Operation Manual

Page: 79 / 98

CNH Pro 700 Set-Up: Injection Pump Calibration 77
CNH PRO 700 SET-UP
PRIME THE INJECTION PUMP
You must prime the injection pump before you perform the calibration procedure.
1. Open the hand valves between the supply tank and the injection pump.
2. Set the hand valve on the injection pump outlet, if present, to recirculate the product to the supply tank.
3. Remove the cover from the injection pump calibrator.
4. Raise the pump calibrator plunger fully.
5. Reinstall the pump calibrator cover.
6. Verify the following:
a. Boom pressure is less than 83 kPa (12 psi).
b. Vehicle ground speed is less than 1.1 km/h (0.7 mph).
c. Vacuum pressure for the injected product is less than 37.9 kPa (5.5 psi).
d. Product application from the main tank if off.
e. Product application from the injection tank if off.
f.
The master Apply button is on.
g. At least one boom section is on.
7. Navigate to the Flowmeter Calibration screen.
8. Use the Rate Controller window to select the rate controller for the pump you intend to prime.
9. Select Prime from the Mode drop-down.
10. Press Start/Stop to begin priming
NOTE: If any condition prevents the priming process from completing successfully, a Prime Fail pop-up
message will display. Acknowledge the pop-up message, resolve the error condition, and restart the
priming process.
When the rate controller detects that the injection pump is primes, a Prime Complete pop-up
message displays.
CALIBRATE THE INJECTION PUMP
1. Ensure that the injection pump is primed as described above.
2. Remove the cover from the injection pump calibrator.
3. Press the pump calibrator plunger down fully.
4. Reinstall the pump calibrator cover.
5. Verify the following:
a. Boom pressure is less than 83 kPa (12 psi).
b. Vehicle ground speed is less than 1.1 km/h (0.7 mph).
c. Vacuum pressure for the injected product is less than 37.9 kPa (5.5 psi).
d. Product application from the main tank is off.
e. Product application from the injection tank is off.
f.
The master Apply button is on.
g. At least one boom section is on.
6. Navigate to the FlowMeter Calibration screen.
7. Use the Rate Controller window to select the rate controller for the pump that you intend to calibration.
8. Select Calibrate from the Mode drop down.
9. Press the Start/Stop button. When the display detects that 0.3 dL (1.0 US fl oz) of liquid has passed through the
pump, a Calibration Complete pop-up message displays. If any condition prevents the calibration process from