Raven Sidekick Pro, Installation And Operation Manual

Page: 66 / 98

C
HAPTER
5
64 CAN Sidekick Pro Injection for Case IH 3/4XXX Installation and Operation Manual
To access the Pressure Settings tab:
1. Touch the Edit icon in the Machine Panel to view the Machine Devices.
2. Locate and select the Product Control button.
3. Touch the Pressure Settings tab.
4. Touch the product indicators along the left of the prompt to select the control channel to which the pump is
assigned. The following Sidekick Pro injection pump settings will be available:
Pressure Cal 1.
Set pressure cal 1 (pump outlet pressure) to zero. Ensure no pressure is on outlet of injection
pump or in the injection lines.
When connected to a Sidekick Pro motor control node, the pressure cal 1 value
will display the pressure at the outlet port of the injection pump.
NOTE: The user may need to prime and calibrate the pump before setting the initial pressure cal 1 value.
PUMP AND PRESSURE TRANSDUCER CALIBRATION
1. Using a 9/16” Allen wrench, or a 9/16” bolt head, loosen the outlet valve cartridge on the opposite side the
pump head from the transducer to release pressure at the injection pump outlet port.
FIGURE 2. Outlet Valve Removal for Pressure Release
NOTE: It is not necessary to completely remove the valve cartridge from the pump head. Loosen the
cartridge to relieve pressure from the pump.
WARNING
Fluid in the injection pump may be under
pressure, even if the system has not been in use
recently. Always wear protective equipment and
use caution when opening a system that has
been previously pressurized.
Edit Product
Control
Pressure
Settings
Pressure Transducer
Outlet
Valve
Cartridge