Raven Sidekick Pro, Installation And Operation Manual

Page: 50 / 98

C
HAPTER
3
48 CAN Sidekick Pro Injection for Case IH 3/4XXX Installation and Operation Manual
3. Secure the hose to the fill valve with two provided hose clamps.
4. Route the hose from the left side of the machine to the rearmost open 1” hose barb fitting on the bottom of
the pump station on the right side of the machine.
FIGURE 70. Dual Pump Fitting Assembly Installed
5. Cut the hose to a length that prevents kinking and damage.
6. Secure the hose to the hose barbs using two of the provided hose clamps.
7. Repeat step 1 to step 6 for the frontmost 1” fill station valve and the frontmost 1” pump station hose barb
fittings.
8. Attach strips of the provided nylon warp to protect the hoses from sharp edges and hot surfaces.
RINSE VALVE PLUMBING
1. Apply the provided thread sealant to all threaded joints.
2. On 3XXX machines, cut a 6” (or less) length of the provided 3/4” hose. On 4XXX machines, cut approximately
18” (or less) of the provided 3/4” hose.
NOTE: Use the shortest length needed to run from the middle port of the rinse valve to the rinse hose tee.
3. Connect one end of the hose to the 3/4” hose barb on the middle port of the rinse tank shut off valve.
4. Secure the hose to the hose barb using two of the provided hose clamps. Connect the other remaining open
end of the hose to the open 3/4” port on the rinse hose tee fitting.
3/4” Rinse Hose Connection
1” Chemical Hose Connections
from Fill Station