Raven AutoBoom Willmar Eagle 8500, Installation Manual

Page: 69 / 82

Manual No. 016-0230-014 63
UltraGlide
FIGURE 14.
Gauge Wheel Installed
1.
Remove the nuts from the left wheel axle (P/N 063-0131-590).
2.
Place the wheel (P/N 322-0131-008) on the left wheel axle.
3.
Align and place the hub retainer bracket (P/N 107-0171-617) over the wheel.
4.
Reinstall the lug nuts on the wheel axle to secure the wheel and hub retainer bracket.
5.
Secure the left wheel mounting bracket (P/N 116-0159-532) to the front of the second left boom using four
1-3/8” W x 2-1/2” L x 5/16” thread U-bolts (P/N 321-0000-330), one 3/8”-16 x 3” hex bolt (P/N 311-0054-
113), and one 3/8”-16 zinc flanged lock nut (P/N 312-1001-164).
6.
Insert the left wheel axle into the left wheel mounting bracket, positioning it so that the bottom of the wheel
touches the ground (or nearly so) and the wheel faces away from the machine.
7.
Secure the gauge wheel assembly in the wheel mounting bracket by installing two 1/2”-13 x 1-1/2” SS hex
bolts (P/N 311-0058-186) and two 1/2” zinc hex nuts (P/N 312-1001-043).
8.
Repeat the steps above to install the right wheel.
Install the UltraGlide Wiring
Wiring Connections
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously
on both the male and female ends of the connectors. Application of the grease will prevent corrosion to the
pins and wires.
CAUTION
Always connect the power cable as the last
step in the wiring process and verify that the
power leads are connected with the correct
polarity. Reversing power leads can cause
severe damage to the equipment.