Raven AutoBoom Willmar Eagle 8500, Installation Manual

Page: 70 / 82

Chapter 5
64 Willmar Eagle 8500 AutoBoom Installation Manual
Mount the AutoBoom Node
FIGURE 15.
AutoBoom Node Installed (Example Only)
1.
Mount the AutoBoom node (P/N 063-0130-013) to the valve mounting plate (P/N 107-0171-802) using three
3/8”-16 x 1-1/4” zinc hex bolts (P/N 311-0054-106) and three 3/8”-16 zinc flanged lock nuts (P/N 312-1001-
164).
Note:
Position the node so that the cable connections face down.
2.
Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-045) into the correct
ports of the Autoboom node.
3.
Tighten the bolts on the node connectors to secure the connections.
Connect the Harness to the Boom Function Controls
1.
Locate the Left Press and Right Press connectors on the AutoBoom harness cable (P/N 115-0230-045 or
115-0230-085).
2.
Route the connectors to the AutoBoom valve (P/N 063-0131-125).
3.
Connect the Left Press connector to Port G1 on the AutoBoom valve.
4.
Connect the Right Press connector to Port G4 on the AutoBoom valve.
5.
Locate the Left Solenoid and Right Solenoid connectors on the harness cable.
6.
Connect the Left Solenoid connector to Port 4A on the AutoBoom valve.
7.
Connect the Right Solenoid connector to Port 4B on the AutoBoom valve.
8.
Locate the Left Prop and Right Prop connectors on the harness cable.
9.
Connect the Left Prop connector to Port 5A on the AutoBoom valve.
10.
Connect the Right Prop connector to Port 13A on the AutoBoom valve.