Raven AutoBoom Willmar Eagle 8500, Installation Manual, Page: 67 / 82

Manual No. 016-0230-014 61
UltraGlide
1.
Locate the left and right ultrasonic sensors (P/N 063-0130-012 and 063-0130-014) in the AutoBoom
installation kit.
2.
Remove the sensor from the existing plastic arm.
3.
Install the sensors on the 12” S-type sensor arms (P/N 063-0131-592) using the supplied 5/16”-18 x 1-1/4”
bolts (P/N 311-0052-106), 5/16”-18 nylon insert lock nuts (P/N 312-4000-059) and 5/16” zinc flat washers
(P/N 313-2300-012).
4.
Secure the right sensor (P/N 063-0130-012) to the front of the right boom (just ahead of the boom
breakaway) using two 2-1/8” W x 2” L x 3/8” thread U-bolts (P/N 107-0171-610) and four 3/8”-16 zinc
flanged lock nuts (P/N 312-1001-164).
5.
Tighten the nuts to ensure the sensor is mounted securely.
6.
Repeat the steps above to mount the remaining boom sensor(s).
Mount the Center Rack Sensor
FIGURE 12.
Center Sensor Mounting Location
1.
Mount the center sensor (P/N 063-0130-018) to the machine’s center rack using two 2-1/16” W x 3” L x 3/8”
thread U-bolts (P/N 107-0171-609) and four 3/8”-16 zinc flanged lock nuts (P/N 312-101-164).
2.
Tighten the nuts to ensure the sensor is mounted securely.
Connect the Sensor Cables
1.
Connect the left sensor cable (P/N 115-0171-527) to the connector on the left sensor.
2.
Route the left sensor cable toward the AutoBoom valve.
3.
Loop and tie-off any excess cable, allowing enough cable for boom folding and extension.
4.
Repeat the steps above to connect the remaining sensor cable(s).
Note:
The sensor cables will be connected to the AutoBoom system in the wiring phase of installation.