Raven AutoBoom Willmar Eagle 8500, Installation Manual, Page: 27 / 82

3
Manual No. 016-0230-014 21
PowerGlide
FIGURE 15.
Machine’s Boom Function Coils
3.
Locate the machine’s boom function coils on the machine’s hydraulic valve.
4.
Locate the left tilt up coil.
5.
Determine which wire feeding into the coil receives the signal from the switches in the cab by pressing the
switch and using a test light or multi-meter to 12 volts.
6.
Locate the Left Solenoid Sense Up connector on the AutoBoom harness cable (P/N 115-0230-003).
7.
Use a 16-18 gauge scotch lock parallel splice connector (p/N 405-2001-079) to connect the left tilt up coil
wire to the Left Solenoid Sense Up connector.
8.
Locate the left tilt down coil.
9.
Determine which wire feeding into the coil receives the signal from the switches in the cab by pressing the
switch and using a test light or multi-meter to 12 volts.
10.
Locate the Left Solenoid Sense Down connector on the AutoBoom harness cable (P/N 115-0230-003).
11.
Use a 16-18 gauge scotch lock parallel splice connector (P/N 405-2001-079) to connect the left tilt down
coil wire to the Left Solenoid Sense Down connector.
12.
Repeat the steps above to connect the right tilt up and down coils to the Right Solenoid Sense Up and
Down connectors on the AutoBoom harness cable.
Connect the Harness Cable to the Controller Cable
1.
Route the AutoBoom harness cable (p/N 115-0230-003) toward the machine’s cab.
Note:
Be sure to allow enough slack in the harness cable to allow for boom racking.
2.
Connect the harness cable to the controller cable (P/N 115-0230-002).
3.
Tighten the connector screw cap to secure the connection.