Raven AutoBoom Willmar Eagle 8500, Installation Manual

Page: 49 / 82

4
Manual No. 016-0230-014 43
PowerGlide Plus
3.
Tighten the connector screw cap to secure the connection.
Note:
Be sure to allow enough slack in the harness cable to allow for boom racking.
Connect the Controller (If Applicable) - Gen I Cable Only
1.
Route the controller cable (P/N 115-0230-007) into the right side of the machine’s cab.
2.
Locate the two controller connectors and connect them to the AutoBoom controller (P/N 063-0130-021).
Note:
The AutoBoom controller should be mounted in the machine’s cab so that the machine’s operator
has easy access to it.
Connect the Field Computer (If Applicable)
Refer to the Installation & Operation Manual and the appropriate wiring schematic beginning on page 44 for
installation and wiring instructions for your specific field computer.
Connect the Power Leads
1.
Locate the power cable that has the red and white power leads at one end.
2.
Disconnect the machine’s connectors from the battery terminals.
3.
Install the red power lead on the positive battery terminal and reinstall the machine’s battery connector.
4.
Install the white power lead on the negative battery terminal and reinstall the machine’s battery connector.