GB
Page 26 of 32
INSTRUCTION, USE AND
MAINTENANCE MANUAL
G1150.30MAGIC - G1150.30MAGICIT
RAVAGLIOLI S.p.A.
7107-M001-0_R
Problem
Possible cause
Remedy
14.0 TROUBLESHOOTING
Possible troubles which might occur to the tyre-changer are listed below. The manufacturer disclaims all
responsibility for damages to people, animals or objects due to improper operation by non-unauthorised personnel.
In case of trouble, call Technical Service Department for instructions on how to service and/or adjust
the machine in full safety to avoid any risk of damage to people, animals or objects.
In an emergency and before maintenance, set the main switch to "0" and lock it in this position.
The arm advance cam is not imme-
diately activated.
1. Supply missed.
2. The control push button is
broken.
1. Connect the supply.
2. Call for technical as-
sistance.
CONTACT AUTHORISED TECHNICAL SERVICE
Do not try and service alone.
The inflation pedals are badly ad-
justed.
Call for technical assist-
ance.
The chuck doesn’t rotate.
The chuck does not reach the
maximum rotation speed.
The mechanical resistance of the
gearmotor system has increased.
Shorten the lenght of a possible ma-
chine extension cable or increase
the conductors section (disconnect
and connect again). Lift the motor
pedal and wait for the automatic
reset.
Turn the chuck unit with-
out wheel for a few minutes
so that the system heats,
thus reducing frictions.
If in the end the chuck does
not accelerate again, call for
technical assistance.
Inverter overload alarm
or
Inverter undervoltage alarm
or
Inverter overvoltage alarm
Wait until the motor system cools
(the machine does not restart if the
temperature level does not go below
the set safety threshold).
Overtemperature alarm.
The chuck doesn’t rotate clockwise. Pedalboard microswitch breakage.
Replace the microswitch.
The chuck doesn’t rotate, but it at-
tempts rotation when the machine
is switched on again.
Pedalboard irreversible
decalibration.
Call for technical assist-
ance.
The chuck rotates slowly but it does
not operate on the motor pedal.
Pedalboard reversible decalibration.
1. Keep the pedal in rest position.
2. Keep the machine connected to
the net.
3. Wait for 30 seconds that the
pedalboard recalibration auto-
matic attempt ends.
The nozzle doesn’t supply air when
the inflation pedal is pressed (Only
for IT version).
