Instructions for Use MPR1 DATALOGGER
Manufacturer:
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany
Page 63 of 98
Device diagnosis:
The results of the last verification carried out are always displayed there. In case of pressure and
temperature this is done automatically.
The test of the alarm system (T-A) generates the sounds and the flashing sequences for physiological
alarms of high and medium priority as well as for technical alarms of medium priority.
4.6.6 Modifying the scaling
The works setting for the scaling option is “Automatic”, which means that the scaling is automatically
adapted to the signal value. Alternatively one of the three following set-up settings can be chosen for the
scaling:
In the device setup window, press
the Scal key.
The currently set scaling is
displayed. In this case,
“Automatic” has been set as the
works settings have not been
changed yet.
In order to change the setting,
press the Menu key. The available
settings will be rendered in the
pull-down menu.
The arrow keys are used to
change the requested settings,
such as to Setup 1. Subsequently
close the window by pressing on
OK.
The scaling settings for Setup 1
have been accepted, but they are
not active yet.
In order to change the settings,
press the Menu key. The available
settings will be rendered in the
pull-down menu. The arrow keys
are used to change the requested
settings, such as Setup 2.
Subsequently close the window by
pressing OK.
This
document
is
for
information
only
