Instructions for Use MPR1 DATALOGGER
Manufacturer:
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany
Page 14 of 98
2.6.2 Information and warning symbols on the bottom side and the type plate of the unit
The symbols on the bottom side of the apparatus at the cable connection sockets [18] to [28] and on the
back side have the following significance:
The patient connections [18], [19], [20], [26], [27], [28] are of type CF and have been classified
as being defibrillation protected.
The caution sign above the patient connections indicates that only accessory parts authorised
by the manufacturer may be connected up to RAUMEDIC MPR 1 DATALOGGER. In this
respect, please observe the instructions for use.
Analogue outputs
Out-1
[25] and
Out-2
[21].
The caution signs above the analogue outputs
Out-1
and
Out-2
indicate that only accessory
parts authorised by the manufacturer may be connected up to RAUMEDIC MPR 1
DATALOGGER. In this respect, please observe the instructions for use.
Power
input for connection of the mains adapter.
Caution – observe the instructions for use ! The caution sign next to the
Power
socket indicates
that only mains adapter, art. No. 284007-002 respectively 284027-001, authorised by the
manufacturer, may be used.
Ext.
Bi-directional digital input / output.
The caution sign below socket
Ext.
indicates that only accessory parts authorised by the
manufacturer may be connected up to RAUMEDIC MPR 1 DATALOGGER. In this respect,
please observe the instructions for use.
PC
Bi-directional digital USB input / output.
The caution sign below socket
PC
indicates that only accessory parts authorised by the
manufacturer may be connected up to RAUMEDIC MPR 1 DATALOGGER. In this respect,
please observe the instructions for use.
Please observe the disposal instructions. Do not put old units into the garbage.
Please observe the instructions on ESD protection.
ESD protection measures: Contact pins of plugs/sockets, which are provided with an ESD
warning label, must not be touched. Connections between these plugs must not be made
without using ESD protection measures. In particular, the causing of high electrostatic
discharges at the labelled points must be avoided. This is supported through the use of
appropriate ESD work clothing, an appropriate ESD working environment (ESD floors) and ESD
packaging. It is recommended that the operator instructs all employees involved in using the
device about the above mentioned ESD measures.
Table 2: Information and warning symbols
This
document
is
for
information
only
