Advanced System Use & Maintenance
User Manual
ApplianceStor
50
Rev. 1, November 2011
68
Figure 97- Auxiliary panel
1.
Front panel SMB (6-1 pin FPSMB) These leads connect the front panel SMBus cable.
2. LAN activity LED (2-pin LAN1_LED, LAN2_LED) These leads are for Gigabit LAN activity LEDs on
the front panel.
3. Chassis intrusion (4-1 pin CHASSIS)
These leads are for the intrusion detection feature for chassis with intrusion sensor or microswitch.
When you remove any chassis component, the sensor triggers and sends a high-level signal to these
leads to record a chassis intrusion event. The default setting is short CASEOPEN and GND pin by
jumper cap to disable the function.
4. Locator LED (2-pin LOCATORLED1 and 2-pin LOCATORLED2) These leads are for the locator
LED1 and LED2 on the front panel. Connect the Locator LED cables to these 2-pin connector. The
LEDs will light up when the Locator button is pressed.
5. Locator Button/Swich (2-pin LOCATORBTN)
These leads are for the locator button on the front panel. This button queries the state of the system
locator.
