Advanced System Use & Maintenance
User Manual
ApplianceStor
50
Rev. 1, November 2011
90
Allows you to enable or disable the parallel port (LPT/LPTE). Configuration options:
[Enabled] [Disabled]
Change Settings [Auto]
Change Settings [Auto]
Change Settings [Auto]
Change Settings [Auto]
Allows you to select an optimal setting for the super 10 device. Configuration options:
[Auto] [I0=378h; IRQ=5]
[I0=378h: IRQ=5, 6, 7, 9, 10, 11, 12] [I0=278h; IRQ=5, 6, 7, 9, 10, 11, 12] [I0=3BCh; IRQ=5, 6, 7, 9,
10, 11, 12]
Mode [STD Printer Mode]
Mode [STD Printer Mode]
Mode [STD Printer Mode]
Mode [STD Printer Mode]
Device
Allows you to select the printer port mode.
Configuration options: [STD Printer mode] [SPP Mode] [EPP-1.9 and SPP Mode] [EPP-1.7 and
SPP Mode] [ECP Mode] [ECP and EPP 1.9 Mode] [ECP and EPP 1.7 Mode]
APM
Figure 121- APM
Restore AC Power Loss [Power Off]
When set to [Power Off], the system goes into off state after an AC power loss. When set to [Power
On], the system will reboot after an AC power loss. When set to [Last State], the system goes into
either off or on state, whatever the system state was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
EuP Ready [Disabled]
When set to [Enabled], all other PME options will be switched off. Configuration
options: [Disabled] [Enabled]
Power On By PCI [Disabled]
[Disabled]
Disables the PME to wake up from S5 by PCI devices.
[Enabled]
Allows you to turn on the system through a PCI LAN or modem card. This feature
requires an ATX power supply that provides at least lA on the +5VSB lead.
Power On By PCIE [Disabled]
