RR27T
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Page 6
21.) Main pump should be removed to check this.
Ensure that Lovejoy rubber is not damaged
If the crankshaft or hydraulic pump shaft sticks through the coupler to get
the right fitment, make sure that the rubber is turned so the shaft fits
into the hollow. Make sure that the keyway does not distort the rubber, if
the keyway is protruding as pictured it will damage the rubber, it must be
pushed down to be level with coupler edge
You should not see the keyway above the coupler. As shown in the picture
the keyway must be tapped down, flush with the coupler
22.) Line the Lovejoy connectors up and trial fit the pump to the motor,
adjust the lovejoys so that there is a small space in between the metal
couplers (approximately 1/16”)
23.) Tighten the bolts holding the housing to the engine and recheck the
spacing on the lovejoy
24.) Install sawdust chute 10mm Nut x Bolt through body, nuts go in the
sawdust collector side.
25.) Remove cotter pin from bottom tube on large safety cover
