RR27T
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Page 15
If unit was purchased without an outfeed conveyor connect unmarked loose
hydraulic hose to open port on return Tee and tighten, then proceed to step
#91.
If unit was purchased with an outfeed conveyor, DO NOT do this step
76.) Open conveyor box, remove shrinkwrap from conveyor, box includes
Conveyor Top Section
Lower Section, includes Hydraulic pump
Top and bottom sections may already be bolted together
Belt
Top Roller
77.) Pull conveyor leg out of holders and re-intall in top tube only, place
lower conveyor in place and install 2 mount bolts, do not over tighten,
conveyor must be able to swing up and down freely
78.) Remove bolts at rear of processor body
79.) Put conveyor in place and re-install bolts, tighten
