RR27T
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Page 19
should not be used
98.) Check adjustment of chainsaw chain, remember this is a chainsaw so
the chain should not be tight, the bottom should hang off the bar slightly
99.) Adjust safety cage hydraulic bypass valve, when the cage is closed this
valve must be completely depressed
100.) Make sure that manual ram engagement bar is in up position, Start
engine and let idle until engine and hydraulic oil are at operating
temperature
101.) While engine is warming up, adjust conveyor belt to run in center of
upper and lower pulleys, upper puller has bolts on either side for adjustment
Lower pulley only has adjustment bolts on side opposite of drive motor
When adjusted properly belt rides in center of lower pulley
102.) When unit is up to operating temperature operate saw and ram
multiple times to make sure they are adjusted and working properly
103.) Shut unit off
104.) Check all nuts, bolts, hose and fittings one more time, check for
leaks
