R&S NGM202, User Manual

Page: 62 / 177

Instrument Functions
R&S
®
NGL200/NGM200
59 User Manual 1178.8736.02 ─ 06
Trigger-in parameters Source Descriptions
CC, CV, CR, Protection, Sink Operation Mode If respective channel operation modes , protection
event or sink mode is detected, corresponding
trigger-out parameters are triggered.
See Figure 6-18 .
User button
*TRG
User button
SCPI command (*TRG)
remotely send to instru-
ment
If detected, corresponding trigger-out parameters
are triggered.
See Figure 6-18 .
Table 6-4: Trigger-out signals
Trigger-out parameters Trigger conditions Descriptions
Output channel Output On
Output Off
Gated
If a trigger is detected, respective channel output
of the instrument turns on or off.
Digital Output Fault CC, CV, CR, Protection
and Sink, Output Off If respective channel operation modes , protection
event or sink mode is detected, a trigger signal is
sent out at pin 11 of the Digital I/O connector .
See Figure 6-19 .
Digital Output Out1 Trigger-in signal
Output On Ch 1
If detected, a trigger signal is sent out at pin 4 of
the
Digital I/O connector .
Digital Output Out2 Trigger-in signal
Output On Ch 2
If detected, a trigger signal is sent out at pin 12 of
the
Digital I/O connector .
Logging Trigger-in signal If detected, the data logger starts recording the
instrument.
Arb Start triggered
Stop triggered
If a trigger is detected, respective channel starts
generating a complete arbitrary signal or steps
through the arbitrary signal for every trigger signal
detected.
The step time from the arbitrary signal is ignored
in the case when trigger condition is set as "Stop
triggered".
FastLog Trigger-in signal If detected, the FastLog module is enabled and
starts acquiring measurement data.
Trigger / Digital I/O