Remote Control Commands
R&S
®
NGL200/NGM200
103
User Manual 1178.8736.02 ─ 06
// selects the output channel, sets the step width
// and increases the voltage in the selected channel
// from 4 Volts
VOLT DOWN
// decreases the voltage in the selected channel
// from 4 Volts
VOLT:STEP?
// queries the voltage step size
// response: "4.000"
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
........................................................ 103
[SOURce:]VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
..............................................103
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
<voltage>
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]?
Sets or queries the voltage value of the selected channel.
Parameters:
<voltage>
numeric | MIN | MAX | UP | DOWN
numeric
Numeric value in V.
MIN
Minimum voltage at 0.000 V.
MAX
Maximum voltage at 20.050 V.
UP
Increases voltage by a defined step size. See
]VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
DOWN
Decreases voltage by a defined step size. See
]VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
on page 103.
Range:
0.000 to 20.05
Default unit: V
Example:
See
Example "Configuring the output voltage"
[SOURce:]VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
<stepsize>
[SOURce:]VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]?
[<stepsize>]
Sets or queries the incremental step size for the
Setting parameters:
<stepsize>
numeric | DEFault
numeric
Step value in V.
Configuration Commands
