WCDMA TPC Measurement
R&S
®
CMW-KG4xx/-KM4xx/-KS4xx
811
User Manual 1173.9657.02 ─ 11
// The trigger source is selected automatically when the scenario is activated.
//
// Set a trigger timeout of 10 s.
// *****************************************************************************
TRIGger:WCDMa:MEAS:TPC:TOUT 10
4.4.2.3
Specifying Limits
// *****************************************************************************
// Configure UE power limits for "Max. Power E-DCH" measurements.
// *****************************************************************************
CONFigure:WCDMa:MEAS:TPC:LIMit:MPEDch ON, 24, 1.7, -6.7
// *****************************************************************************
// Configure power step limit for "Change of TFC" measurements.
// *****************************************************************************
CONFigure:WCDMa:MEAS:TPC:LIMit:CTFC 2.2, ON, 7
// *****************************************************************************
// Configure power step limit for "Power Control in UL CM" measurements,
// CM test type pattern A and B.
// *****************************************************************************
CONFigure:WCDMa:MEAS:TPC:LIMit:ULCM:PA 5 1 5
CONFigure:WCDMa:MEAS:TPC:LIMit:ULCM:PB 3 2
4.4.2.4
Setting up a Connection to the UE
// *****************************************************************************
// Connect the UE (switched off). Switch on the DL signal. Query the cell
// state until it equals ON,ADJ (DL signal available at RF connector).
// *****************************************************************************
SOURce:WCDMa:SIGN:CELL:STATe ON
WHILE SOURce:WCDMa:SIGN:CELL:STATe:ALL? <> "ON,ADJ"
// *****************************************************************************
// Switch on the UE and wait until it is registered and attached.
// *****************************************************************************
WHILE FETCh:WCDMa:SIGN:CSWitched:STATe? <> "REG"
WHILE FETCh:WCDMa:SIGN:PSWitched:STATe? <> "ATT"
// *****************************************************************************
// Set up the test mode connection. For subtest 1 the wizard configures
// an RMC connection and an HSPA connection.
// Query the connection state until the connections have been established.
// *****************************************************************************
CALL:WCDMa:SIGN:CSWitched:ACTion CONNect
WHILE FETCh:WCDMa:SIGN:CSWitched:STATe? <> "CEST"
WHILE FETCh:WCDMa:SIGN:PSWitched:STATe? <> "CEST"
Programming
深圳德标仪器
135-1095-0799