Rancilio EGRO 5511, Technical Manual

Page: 11 / 70

EGRO 5511 Manual
The Egro 5511 requires a NEMA L6-30R recep-
tacle (
P1
). The optimal voltage supply is 230V.
Acceptable range is 208V - 250V. If below 208V,
a voltage booster may be required. If above 250V,
a buck n’ boost transformer may be required.
Egro machines do not use a neutral line. A dedi-
cated ground wire is required for proper perfor-
mance.
ELECTRICAL CONNECTIONS
NEMA L6-30R receptacle
= Ground
= Hot leg
P
1
The incoming water supply should be a male 3/8”
NPT fitting.
The water connector on the Egro 5511 is 3/8”
BSPT.
A 3/8” NPT to 3/8” BSPT fitting will be needed to
connect the incoming water supply to the water
connector of the Egro 5511.
A water softener/filter for the incoming water
supply is
REQUIRED .
Connect the incoming water to the softener/filter
and flush with approximately 3 gallons of fresh
water.
Then connect the other end of the softener/filter
to the Egro 5511.
WATER CONNECTIONS
(It is recommended that 2 persons perform the steps below)
Locate the four feet provided (
P2
).
FEET INSTALLATION
Foot
P
2
Slowly tilt the Egro 5511 to the right, and screw in
two legs to the bottom left side.
Carefully tilt the Egro 5511 onto the newly
installed legs and screw in the remaining two legs
to the bottom right side.
Locate the two bean hoppers provided. Slide the
hoppers down into the rubber grinder collars on
top of the Egro 5511 (
P3
).
No screws or other fasteners are required for
installation.
BEAN HOPPER INSTALLATION
Top view,
with collars
circled
P
3
After installing the hoppers, fill them with fresh
coffee beans.
Left hopper = Regular.
Right hopper = Decaf.
Page 11