Page 14
WES+ Installation and Operations Manual V2.3 Ramtech Electronics 2017
All settings are protected from unauthorised change by an access
code. By default, this is set to 1234. The access code can be reset
by deactivating and then activating the base station. All site specific
information will be cleared upon activation.
Change Access Code
We recommend that you change the default 1234 access code to a
secure code specific to site.
To change the access code, navigate down the Settings Menu until the
Change Access Code option is highlighted as shown. Press Enter to
select.
The existing Access Code will then be requested, as shown below.
The new Access Code then needs to be entered twice.
Confirmation of the Access Code change will be displayed.
Unit Numbering
B
y default, every WES+ unit is numbered 001 when activated. This unit
number can be changed so that you can assign unique identification
numbers to individual units or create groups of units with the same
number to enable you to pinpoint where an alarm has been triggered
or other fault identified.
This is done using the Unit Numbering feature, and any number
between 001 and 999 may be used.
Units must be either freshly activated or already paired to a unit on
the same site as the base station before renumbering.
To number a unit from a different site network, you will first need to
deactivate and reactivate the site to remove the information specific to
the original site.
Select the number you wish to assign to a particular WES+ unit using
the navigation pad. Once the correct number is displayed, press and
hold the A buttons on both the base station and the unit you are
numbering. The amber LEDs on both units will illuminate and then the
green LEDs will flash to confirm successful renumbering.
To exit the Unit Numbering screen, press the left arrow when at the left
most digit of the unit number.