Page 16
WES+ Installation and Operations Manual V2.3 Ramtech Electronics 2017
Reassemble of the Lid
1. Reattach the facia (19-way ribbon) to the PCB and reconnect the
battery connector.
2. Position the lid so that it is higher. (Fig1.)
3. Slide in place, ensuring that it aligned with the screws. (Fig 2)
4. Ensure that there are no trapped wires in between the lid and the
base
5. Screw down the lid using the T20 screwdriver with a maximum of
2Nm Torque.
Fig. 1
Direction is iindicated by the
orange arrow
Fig. 2
Starting point of the lid with screws.
Highlighted in Orange
Sim Card installation - GSM Base Station
Before installation the following parts and tools are required:
•
Sim Card
•
T20 Torx Screwdriver
Please ensure that you are in an ESO protected area before
undertaking the installation of the Sim card into the WES+
Base Station
The unit must be switched off and in Transit mode
Removal of the Lid
1. Using the T20 Torx screwdriver, remove all four screws from the
base station lid. (Fig. 1)
2. Slide the lid upwards to ensure that the tamper leaver does not
short circuit. (Fig. 2)
3. Carefully lift the lid, and disconnect the fascia (19 way ribbon)
from the PCB. Disconnect the battery connector.
4. Turn the lid over. Take the sim card and insert into the sim slot
as shown below. Make sure that the sim card connections are
facing down.
5. Now you are ready to reattach the fascia (19-way ribbon) to the
PCB, and reattach the lid.
Fig. 1
Removal of screws -
highlighted in Orange
Fig. 2
Sllide the lid upwards.
You can now switch on the unit.
Hold down the ‘A” button and press the ‘B’ button 3 times, to set up.
When you switch the unit on, you will see the following screen
Next press the menu button.
From the next menu
WES+ Main Menu
select
Settings.
You will be asked to enter an access code (see overleaf). The default
code is
1234
unless your change it.
Reassemble of the Lid
1. Reattach the facia (19-way ribbon) to the PCB and reconnect the
battery connector.
2. Position the lid so that it is higher. (Fig1.)
3. Slide in place, ensuring that it aligned with the screws. (Fig 2)
4. Ensure that there are no trapped wires in between the lid and the
base
5. Screw down the lid using the T20 screwdriver with a maximum of
2Nm Torque.
Fig. 1
Direction is iindicated by the
orange arrow
Fig. 2
Starting point of the lid with screws.
Highlighted in Orange
Sim Card installation - GSM Base Station
Fig. 1
Removal of screws -
highlighted in Orange
Fig. 2
Sllide the lid upwards.
You can now switch on the unit.
Hold down the ‘A” button and press the ‘B’ button 3 times, to set up.
When you switch the unit on, you will see the following screen
Next press the menu button.
From the next menu
WES+ Main Menu
select
Settings.
You will be asked to enter an access code (see overleaf). The default
code is
1234
unless your change it.
