446
SERVICING AND MAINTENANCE
Fog Lamps — If Equipped
Please see an authorized dealer for service on
LED and Halogen front fog lamps.
Halogen
See below steps to replace:
1. Reach under and behind the front fascia/
bumper to access the back of the front fog
lamp housing.
2. Disconnect the fog lamp wiring harness
connector from the fog lamp bulb.
3. Rotate the bulb counterclockwise a quarter
turn to unlock the bulb from the housing.
Fog Lamp Bulb
4. Pull the bulb straight out from the housing.
Rear Tail/Stop, Turn Signal And Backup Lamps
See below steps to replace:
1. Remove the two screws and push pins that
pass through the bed sheet metal.
Tail Lamp Locations
2. Pull the outboard side of the lamp rearward
far enough to unsnap the two receptacles
on the outboard side of the lamp housing
from the two plastic snap post retainers in
the outer box side panel.
Tail Lamp Removed
3. Disconnect the wiring harness connectors
from the bulb socket.
4. Rotate the bulb socket counterclockwise a
quarter turn to unlock it from the housing.
5. Pull the bulb straight out of the socket.
CAUTION!
Do not contaminate the bulb glass by
touching it with your fingers or by allowing it
to contact other oily surfaces. Shortened bulb
life will result.
1 — Tail Lamp
2 — Screws
3 — Fasteners
21_DJD2_OM_EN_USC_t.book Page 446
