Chapter 4 Operation
WinLink 1000 Installation and Operation Manual
Exiting WinLink Manager (Exit button)
•
Menu bar
File Menu – Log off, and exit
Configuration – use for link configuration, individual site
configuration or link installation
Tools – set preferences, event log handling, change password
Maintenance – Loopbacks, system reset.
•
Link details pane – summarizes information on the radio frequency,
air interface rate, type of TDM service, and IP details of the local
and remote WinLink 1000 units.
•
Monitor pane – displays the link quality between local and remote
devices and the following statistics:
Local/remote received traffic rate (in kbps)
Local/remote received frames rate (in fps)
Radio link status
E1 or T1 link status
Radio signal strength (RSS) in dBm
Block error rate
•
Event log – stores both alarms and traps:
Alarms and traps also generated by NMS (e.g. counter clear,
device unreachable, etc.)
•
Traps:
Monitoring for radar activity on channel <frequency> GHz. –
Apply to DFS/TPC products only. T trap is issued when the ODU
starts the looking for radar.
Radar activity was detected in <site>, on channel <frequency>
GHz. Apply to DFS/TPC products only. The ODU detected radar.
The channel is prohibit for 30 minutes.
Transmitting on channel <frequency> GHz. – The ODU started
transmission on a channel.
Channel scanning in progress. The ODU start searching the
remote ODU in all channels.
Configuration problem detected. Link installation required.
4-6
Managing WinLink 1000
Summary of Contents for WinLink 1000
Page 2: ......
