NOTE 1: When two RipEX units are connected via their Ethernet ports in the same LAN,
their IP networks defined on Radio interface must not overlap (both units would reply to the
same ARP request).
NOTE 2: It is highly recommended to activate ARP proxy as the last change when all the
other settings are done.
NOTE 3: Check your routing rules twice – routing within a single LAN requires careful IP
address planning to fit as narrow subnet masks as possible for the individual routes.
Note
You may add a note to each line up to 16 characters long (UTF8 is supported) for your con-
venience. (E.g. "Remote unit #1 etc.). Following characters are not allowed:
" (Double quote)
` (Grave accent)
\ (Backslash)
$ (Dollar symbol)
; (Semicolon)
Active
You may tick/untick each line in order to make it active/not active. VLAN is active when at
least one of its subnets is active (even the first line can be inactive).
Modify
Add Subnet creates the new Subnet line. Add VLAN creates the new VLAN line. Delete deletes
respective line. The VLAN lines can be sorted using up and down arrows.
RipEX Radio modem & Router – © RACOM s.r.o.
142
Advanced Configuration
Summary of Contents for RipEX
Page 2: ......
