RACOM RipEX, User Manual

Page: 54 / 234

4.3. Indication LEDs
Fig. 4.15: Indication LEDs
Tab. 4.5: Key to LEDs
Description Color
The RipEX OS (Linux) is running
successfully
Green
STATUS
Reset button has been pressed Dark
reset after five-seconds pressing
the Reset button
Green flashes slowly
default access after 15-seconds
pressing the Reset button
Green flashes quickly
Emergency Red flashes quickly
Alarm Red
GPS module synchronized,
for RipEX-xxxG model only Green
blinks with a period of 1 sec
TX
transmitting to radio channel Red
receiver is synchronised to a
packet
Green
RX
there is a signal stronger than
−80 dBm on Radio channel
Yellow
data receiving Green
COM2
data transmitting Yellow
data receiving Green
COM1
data transmitting Yellow
100 Mb/s speed Yellow ON
ETH
10 Mb/s speed Yellow OFF
connected Green ON
Ethernet data Green flashes
powered successfully Green
PWR Save mode Blinks with a period of 1 sec
Sleep mode Flashes once per 3 sec
Alarm – is “On” when any controlled item in Alarm management, (see Adv. Conf., Alarm man-
agement for more) is in alarm status (out of thresholds) and “SNMP Trap", "HW Alarm
Output" or "Detail graphs start” for any line in the Alarm configuration table are checked.
Emergency – Emergency status is an undefined RipEX status either because of a SW or HW problem
when RipEX does not function properly. Maintenance web page is mostly accessible
even in Emergency status. If the problem cannot be eliminated after a power cycle, send
the unit to RACOM for repair.
RipEX Radio modem & Router – © RACOM s.r.o. 54
Product