Racepak Ultra Dash Xtreme, Installation And Operation Instructions Manual

Page: 5 / 41

Introduction
1
Introduction
This manual contains the information required to install and program your Ultra Dash. If you have
purchased the PC download kit, you should have received a DataLink manual as well. Refer to the
DataLink manual for information on using the DataLink software to view the data from your dash.
Six Button Dash Features
•
Engine and jack shaft RPM.
•
Speedometer
•
Four exhaust gas temperature inputs. (sensors sold separately)
•
One water temperature.
•
Ace M10 setting input.
•
Warning indicator inputs for the following items:
o
Low oil
o
Water temperature
o
High beam
o
Detonation
o
Premium fuel
•
External warning indicator output.
•
Internal warning indicator light.
•
Internal high beam indicator light.
•
V-Net port for expansion of up to 5 additional channels.
•
Ten minutes of record and playback memory.
•
Minimum and Maximum recall.
•
Electro luminescent(EL) back light.
Package Contents
The Ultra Dash kit should contain the following components:
1 – 6 Button Ultra Dash Display
1 – 12 position connector and wires
1 – 15 position connector and wires
1 – Water temperature sensor
1 – Jack shaft RPM sensor (jack shaft collar and magnet sold separately)
1 – Remote switch
1 – Wire terminal kit
1 – Instruction manual
1 – Cut out template
If you are missing any of the above components please contact your dealer immediately.
Optional Items:
o Jack shaft collar. Required for speedometer. Available sizes: 0.75”, 1.00”, 1.125”, 1.25”
o Data transfer to DataLink PC analysis software.