Racepak Ultra Dash Xtreme, Installation And Operation Instructions Manual

Page: 22 / 41

Programming and Operation Using the Dash Buttons
18
Does nothing Does nothing Does nothing
Does nothing Does nothing Does nothing
Table 6
Table 7 shows the channel tags appearing in the lower left position while in scroll mode.
Abbreviation Description
ERPM
Engine RPM
DRPM
Jack shaft RPM
MPH
Speedometer in MPH or KPH units
RMSW
Remote switch state. 0 = open 1 = closed
EGT1
Exhaust Gas Temperature 1
EGT2
Exhaust Gas Temperature 2
EGT3
Exhaust Gas Temperature 3
EGT4
Exhaust Gas Temperature 4
H2OT
Water temperature
VOLT
External battery volts when running on external battery power. Rectified volts
when running on main AC/DC power.
RAT
Engine to jack shaft ratio. Engine RPM divided by Jack Shaft RPM
TIME
Real-time mode = Seconds since unit was turned on or recording was started
Playback mode = Seconds since recording was started
Table 7
In addition to the channels built in to the dash, which are listed above, you can use scroll mode to view
channels that have been added using the V-Net port. Refer to the information provided with the V-Net
module for the channel tag.
Note: The channel tags listed in table 7 are the factory defaults. The tag can be changed using the
DataLink PC software.