Racepak Ultra Dash Xtreme, Installation And Operation Instructions Manual, Page: 8 / 41

Ultra Dash Installation
4
Port A Wiring
Port A uses the 15 position connector. The only factory installed wires in the port A connector are the ones
required for power and ground. All other wires are provided with the pins crimped and ready to install if
needed. A description of each wire and its function is described below. If you decide not to use an input
you may leave the wire uninstalled.
Pin 1 – Fuel Level Sensor Input – 0-5 volt input. Not used in most applications. Can be connected to any
standard fuel level sensor.
Pin 2 – Ace M10 Suspension Control Input –
When the orange wire is connected the Ace setting will be
displayed in the upper left hand corner of the dash. Insert the orange wire in pin position 2. Connect the
other end of the orange wire to the Ace M10 controller gauge output wire.
Pin 3 – Not Used.
Pin 4 – Premium Fuel Indicator Input –
Grounding the brown wire will cause the premium fuel indicator
to activate. Insert the brown wire in pin position 4. Connect the other end of the brown wire to the factory
installed premium fuel indicator wire.
Pin 5 – Detonation Indicator Input – Grounding the pink wire will cause the Detonation indicator to
activate. Insert the pink wire in pin position 5. Connect the other end of the pink wire to the factory
installed detonation indicator wire.
Pin 6 – High Beam Indicator Input – Applying power to the green wire will cause the high beam
indicator light in the upper right corner of the dash to activate. Insert the green wire in pin position 6.
Connect the other end of the green wire to the high beam wire.
Pin 7 – High Water Temperature Indicator Input – Grounding the gray wire will cause the high water
temperature indicator to activate. Insert the gray wire in pin position 7. Connect the other end of the gray