Ultra Dash Installation
6
Port B Wiring
Port B uses the 12 position connector. Since all port B inputs are optional the wires are provided with the
connector pins crimped but the wires are not installed in the connector. A descrip tion of each wire and its
function is described below. If you decide not to use an input you may leave the wire uninstalled.
Pin 1 – Water Temperature Sensors
– Insert the green/white wire in pin position 1. Connect the
green/white wire to the optional water temperature sensor. This sensor is used to read the actual
temperature in degrees F or C. Do not confuse this input with a high water temperature alarm switch input.
If you would like to use the factory installed temperature alarm switch do not use this wire. See
Port A
Wiring
pin 7 for instructions.
Pin 2 – EGT #1 Probe Positive
– Insert the yellow wire from EGT #1 probe in pin position 2.
Pin 3 – EGT #1 Probe Negative
– Insert the red wire from EGT #1 probe in pin position 3.
Pin 4 – External Battery Ground
– Connect this wire only if you plan to use an external DC battery to
power the dash when the engine is not running. Insert the black wire in pin position 3. Connect the black
wire to the ground wire on the external battery.
Pin 5 – EGT #2 Probe Positive
– Insert the yellow wire from EGT #2 probe in pin position 5.
Pin 6 – EGT #2 Probe Negative
– Insert the red wire from EGT #2 probe in pin position 6.
Pin 7 – External Battery Positive
– Connect this wire only if you plan to use an external DC voltage Ni-
Cad battery to power the dash when the engine is not running. Insert the blue/white wire in pin position 7.
Connect blue/white wire to the positive wire on the external battery. Note: A minimum of 9 volts is
required to properly power the dash. DO NOT CONNECT THIS WIRE TO THE ENGINE LIGHTING
COIL OR ANY OTHER AC VOLTAGE SOURCE. DOING SO WILL CAUSE SEVERE DAMAGE TO
YOUR DASH AND WILL VOID YOUR WARRANTY!!!
Pin 8 – EGT #3 Probe Positive
– Insert the yellow wire from EGT #3 probe in pin position 8.
Pin 9 – EGT #3 Probe Negative
– Insert the red wire from EGT #3 probe in pin position 9.
Summary of Contents for Ultra Dash Xtreme
