IQ3 Drag Dash Installation Manual
17
Pin
Position
Description
Color
Function / Wiring
6
Tail Lights
(Dim lighting)
Light Green
Connect to the “lights” signal circuit on the
vehicle. Applying power to this input will
cause the IQ3 Drag Dash to go into night
mode (dimmed settings for all lights will be
used).
7
Not Used
N/A
8
External Shift
Light
Orange/White
Optional, if an external remote shift light is
desired. Connect to the negative side of the
shift light. Apply a fused 12 volt power
source that is hot only when the ignition
switch is on to other terminal on shift light.
This output applies ground to the circuit
when shift point values are met. 750mA
ground sink maximum
9
Tachometer
Yellow
Connect this input to the tach output signal
from your ignition box. The tachometer
input requires a standard 5 – 20 volt, 50%
duty cycled square wave signal to work
properly.
DO NOT CONNECT THIS WIRE
DIRECTLY TO THE IGNITION COIL. DOING
SO CAN DAMAGE THE CIRCUIT.
10
Not Used
N/A
11
Oil Pressure
Sensor Power
5v output
Red
Connect to the supplied oil pressure sensor
Short circuit protected, 50mA max
(shared between all Sensor 5v outputs)
12
Oil Pressure
Sensor Ground
Black
Connect to the supplied oil pressure sensor
13
Oil Pressure Signal
Clear
Connect to the supplied oil pressure sensor
14
Sensor 5v output
(not used)
N/A
Not used for factory supplied sensors.
Optional, available to supply regulated 5
volts out for aftermarket sensors.
Short circuit protected, 50mA max
(shared between all Sensor 5v outputs)
15
Sensor ground
(not used)
N/A
Not used for factory supplied sensors.
Optional, available to supply ground for
aftermarket sensors.
16
Sensor signal
(not used)
N/A
Not used for factory supplied sensors.
Optional, available to accept signal for
aftermarket sensors.
