![background image](http://html1.mh-extra.com/html/r-v-r-elettronica/pj5kps/pj5kps_users-and-technical-manual_3098838019.webp)
PJ5KPS
13 / 80
User & Technical Manual
Rev. 1.5 - 08/02/06
The modules have a groove at the top and one at the bottom: insert the modules
so that the guides in the compartment fit into these grooves. Slide the module
until the two fixing screws fit into their seats. Then tighten the fixing screws at the
same time so that the module inserts into its compartment remaining parallel until
it is perfectly in place.
4. Repeat the operation with the other four RF modules.
5. Insert the first transformer carriage into the left-hand side of the specific
compartment. The carriage is mounted on three wheels (two are fixed on the front
side and one pivoting rear wheel) to facilitate this operation. Move the carriage
toward the left-hand wall of the rack [Figure 5-3] and then move it forward until the
connectors at the back are perfectly in-serted into their seats.
!
The power supply unit carriage is very heavy and its barycenter is high, therefore be
careful when handling it to avoid tipping it over.
6. If you have a redundant power supply unit, insert the second power supply unit
carriage as you did with the first one.
7. Position the stop bar of the power supply unit carriages.
8. Make the necessary connections of the power supply unit carriages :
• Power supply connector [Figure 5-4 a)]
• Data connectors [Figure 5-4 b)]
9. Connect the machine's main power supply cable. Route the cable (5-pole type)
through the raceway on the machine's roof [Figure 5-5 a)] and fix the conductors
to the terminals of the master switch [Figure 5-5 b)]. The last operation is usually
performed by removing the knob and the cover of the isolating switch.
Figure 5-3
Power supply carriage connectors
Summary of Contents for PJ5KPS
Page 1: ...PJ5KPS User Technical Manual Manifactured by Italy ...
Page 4: ...This page intentionally left blank ...
Page 6: ...PJ5KPS ii User Technical Manual Rev 1 5 08 02 06 This page was intentionally left blank ...
Page 86: ...PJ5KPS 80 80 User Technical Manual Rev 1 5 08 02 06 This page was intentionally left blank ...