![background image](http://html1.mh-extra.com/html/r-v-r-elettronica/pj5kps/pj5kps_users-and-technical-manual_3098838017.webp)
PJ5KPS
11 / 80
User & Technical Manual
Rev. 1.5 - 08/02/06
5. Installation and use
This chapter contains the basic instructions for installing and using the PJ5KPS
amplifier. If necessary, more in-depth information about the operating principles may
be traced in the next chapters.
5.1 Assembly
For practical reasons and for transport safety, the machine is usually supplied disas-
sembled to the customer. The assembly procedure is rather simple and can be car-
ried out by any qualified technician.
Caution:
In order to avoid the risk of damaging the machine and/or of injuring the
operators, it is advisable to closely adhere to the instructions provided below. always
respect all the safety regulations and standards in force.
Identify the machine components:
•
The rack (various components are assembled, such as the coupler, the splitter,
the control unit, the main blower) [Figure 5-1 a)]
•
The 5 RF modules [Figure 5-1 b)]
•
One or two transformer/rectifier carriages [Figure 5-1 c)]
•
The exciters [Figure 5-1 d)]. (As a rule the amplifier is supplied as a complete
transmitter. This example shows two PTXLCD exciters produced by R.V.R.
Elettronica. Usually the exciters are pre-assembled inside the rack).
Check that all the components are in perfect working order. Should there be any kind
of problem, for instance if there is any damage caused by the transport of the
components, read the instructions associated with the Warranty at the beginning of
this manual (chapter 2).
1. Install the rack in the location where the transmitter will work. The rack is mounted
on wheels for simplifying its movement, therefore after having positioned it where
expected, it is advisable to use the four screws at the bottom of the rack to steady
it perpendicular to the ground.
The transmitter is cooled by forced ventilation. The air outlet is on the machine's
roof whereas in the standard configuration the air intake is envisaged at the back
of the machine. If you opt for this solution, install the machine at least 50 cm. away
from the back wall, so that air can flow under optimal conditions. The air inlet may
also be delivered from the machine's roof, by removing the cover from the hole
that is pre-cut in the roof for this purpose.
2. Remove the protection panels of the RF modules and the power supply unit
carriages from the rack. Also remove the stop bar of the power supply unit
carriages that is at the bottom of the rack.
Summary of Contents for PJ5KPS
Page 1: ...PJ5KPS User Technical Manual Manifactured by Italy ...
Page 4: ...This page intentionally left blank ...
Page 6: ...PJ5KPS ii User Technical Manual Rev 1 5 08 02 06 This page was intentionally left blank ...
Page 86: ...PJ5KPS 80 80 User Technical Manual Rev 1 5 08 02 06 This page was intentionally left blank ...