Chapter 3: Installing Your Tape Drive
3-8
January 2004
81-81191-01 Rev A01
3.2.5 Completing the Installation
1.
Secure the SCSI cable connectors by tightening the screws until snug.
N
OTE
:
If your SCSI cable does not fit the connector on your SCSI host adapter,
you either have an incompatible SCSI host adapter or you need to
purchase a cable adapter. Contact your Quantum sales representative or
your SCSI host adapter manufacturer for information.
2.
Make sure the power switch on the rear panel of your tape drive is in the OFF position (tabletop
model only). Attach the female connector on the power cable to the power connector on the rear
panel of the tape drive, as shown in
Figure 3-5
.
3.
Connect the power cables to the server or workstation and all peripheral devices.
4.
Plug the power cable into a nearby power outlet.
5.
Power on your tape drive and any other devices you powered off earlier.
6.
Power on the server or workstation and allow its operating system to start.
7.
Check your tape drive to make sure it is working properly. See
“Indicator Activity During Power-
On Self-Test (POST)” on page 4-2
to learn about your tape drive’s self-test and initialization
features.
Summary of Contents for ValueLoader DLT VS160
