Chapter 3: Installing Your Tape Drive
3-16
January 2004
81-81191-01 Rev A01
6.
Obtain a SCSI cable with an open 68-pin, high-density connector.
7.
Connect one end of the SCSI cable to the SCSI connector on the rear panel of your tape drive. The
SCSI connectors are keyed, preventing improper connection.
8.
Connect the other end of the SCSI cable to the SCSI host adapter, aligning the colored stripe on the
cable with pin 1 on the SCSI host adapter’s connector.
9.
Locate an available power cord in the server or workstation and attach it to the power connector on
the rear panel of your tape drive. The connector is keyed, preventing improper connection.
N
OTES
: 1
If the SCSI cable does not fit the connector on your SCSI host
adapter, you either have an incompatible SCSI host adapter or
you need to purchase a cable adapter. Contact your Quantum
sales representative or your SCSI host adapter manufacturer
for information.
2
Refer to
“Terminating Your Internal Tape Drive” on
page 3-12
to determine if you need to use an LVD/SE
terminator with the SCSI cable.
Figure 3-11.
SCSI and Power Cable Location (Internal Tape Drive)
Power
cord
SCSI cable
(shown with terminator installed)
Summary of Contents for ValueLoader DLT VS160
