Appendix E: Visual Inspection Procedure for DLTtape Cartridges
Quantum DLT 8000 Tape System
E-5
6.
Ensure that the tape leader within the tape cartridge is in
the correct position. To do this, you must open the tape
cartridge door. Refer to Figure E-3.
Figure E-3 Opening the Door on a DLTtape Cartridge Showing Tape Leader Loop in its
Correct Position
Open the door by holding the DLTtape cartridge as shown
in Figure E-3.
On the right side corner of the tape cartridge there is a
small tab in a cut-out portion of the cartridge. Using your
thumb, gently lift up on the tab and swing the door open
(Figure E-3).
Inside the door, you will see the tape and cartridge leader
loop. The loop should stick up about an eighth of an inch
when viewed from the edge; the loop must be a closed loop.
If the loop is torn, bent, pulled in, or not sticking up about
an eighth of an inch, do not use the tape cartridge.
Leader Loop
Summary of Contents for DLTtape DLT 8000
