5-2
Chapter 5: Making Connections
Model 801GC, 801GF & 801GX ¥ Rev. A
Line Voltage Selector
Make certain that the voltage selector switch is set
correctly before plugging the 801G* in.
❖
Operating the 801G* with the wrong AC line
voltage setting or adjusting the line voltage se-
lector switch while the generator is plugged in
may cause serious damage to the generator. This
type of damage is not covered under the prod-
uct warranty nor service contracts.
You will find a recessed AC line voltage selector on
the left side of the 801G* cabinet. This selector has
two positions:
• 115V - for use with line voltages between 86
and 132 VAC @ 48 to 66 Hz
• 230V - for use with line voltages between 180
and 250 VAC @ 48 to 66 Hz
The 801G* is shipped from the factory with the line
voltage selector set for 115V.
❖
If the voltage in your area is greater than 180V,
you must adjust the voltage selector to 230V
before plugging in the generator.
Selecting a line voltage.
The line voltage selector can be changed using a
pen, screwdriver, or similar pointed tool.
1.
Make sure that the 801G* power cord is un-
plugged.
2.
Insert tool into the voltage selector slot.
3.
Push against the side of the slot closest to the
voltage label.
4.
Slide the selector toggle until the correct line
voltage comes into full view.
Summary of Contents for 801GC, 801GF, 801GX
