- 27 -
11. TRANSMISSION DISTANCE INSPECTION
With the help of the “
TEST
” button of the thermostats you can check whether the selected
thermostat and the receiver unit are within the transmission distance of the radio-
frequency connection. To perform the test, press the “
TEST
” button for approximately
3 seconds. Following this, the thermostat will send, alternating every 5 seconds,
switch-on and switch-off control signals to the receiver for 2 minutes (the
signal appears
and disappears alternately on the display). When detecting the
ON
and
OFF
control
signals, associated with the thermostat on the receiver unit, and on the
COMPUTHERM
Q1RX
socket the red LED switches on and off respectively. When the receiver unit/socket
fails to receive signals sent by the thermostat, then the receiver unit/socket is outside the
transmission distance of the wireless (radio-frequency) transmitter, thus they have to be
placed closer to each other.
ATTENTION!
If the two parts of the device can only be placed on the edge of the wireless
(radio-frequency) range or out of it (due to the floor-plan of the house or the shading effect
of its structure), to guarantee the safe wireless connection, place a
COMPUTHERM
Q2RF
wireless repeater between the two parts.
